Tips on Using Imote2
From Cyber-Physical Systems Laboratory
Jump to navigationJump to search- Washington State University has a great wiki with instructions on how to configure your platform to support the Imote2.
- The Imote2 uses the FTDI USB chip whose drivers may be downloaded here.
- Toggling an External Pin on the Imote2
- When sending over UART, make sure the debug board is connected.
- In TinyOS, TOS_LOCAL_ADDRESS is the last 2 digits of the mote id in hex
- Even though the default maximum message size is 29 bytes, the Imote2 will only send a message if it has an even length. The call to GenericComm.sendMsg will actually return FAIL if you try to send a 29 byte long packet.
- Size of local variable array is very small. If you want to use a large array, you need to declare it globally. E.g. realA, PS, W arrays.
- How to change frequency channel of radio on imote2 ????? !!!!!!